STMicroelectronics

STCH03L
Demoboard EVLSTCH03-36W-SR

36W USB charger with selectable output voltage (5-9-12 V @3A) based on STCH03L and SRK1000B

Topologie: Flyback
Eingangsspannung (min.): 90.00 V
Eingangsspannung (max.): 264.00 V
Ausgang 1: 12.00 V / 3.000 A

Erstveröffentlichung am 14.08.2019, Version 1 vom

Beschreibung

The EVLSTCH03-36W-SR shown in the image here is a 36 W wide-range mains USB charger demonstration board, with selectable output voltage (5 - 9 - 12 V @ 3 A output current), based on the STCH03L and SRK1000B. The power circuit is a quasi-resonant (QR) flyback converter, with peak current mode control, based on the STCH03L IC. The circuit operates with secondary side constant voltage (CV) regulation through an optocoupler and is capable of providing constant output current (CC) regulation using primary sensing feedback. The STCH03L embeds a 650 V, non-dissipative, HV startup cell, which, along with the extremely low quiescent current and burst-mode management, helps minimize residual input consumption, thus achieving less than 20 mW under no-load condition. At secondary side, the SRK1000B controller implements synchronous rectification to increase system efficiency: it controls the synchronous rectifier MOSFET, driving its gate with minimal turn-on delay and maximizing the turn-off time instant (through an adaptive mechanism) so that the residual conduction of the SR MOSFET body diode after turn-off reduces to the target value of 300 ns. The charger is designed to meet the most stringent energy saving recommendations (Eu CoC rev. 5 - Tier 2 and EPS of DOE USA) as well as EMI regulation EN55022-Class-B for line conducted noise emissions.

Merkmale

  • Universal AC mains input voltage range: 90 V to 264 V
  • Output voltage: 5
  • 9
  • 12 V selectable @3 A continuous operation
  • Constant voltage (CV) regulation with optocoupler and constant current (CC) regulation with primary side sensing
  • No-load consumption < 20mW at 230 VAC (with load disconnected from charger)
  • 4 points average efficiency and 10% load efficiency in compliance with Eu CoC rev. 5
  • Tier 2 (2016)
  • Line conducted EMI in compliance with EN55022
  • Class B
  • Small form factor (73 x 55 x 15 mm)
  • RoHS compliant

Artikel

  Artikel Nr. SPEC Produktserie Anwendung Interface typ Typ Gender Pins Montageart IR 1
(A)
Arbeitsspannung
(V (AC))
Verpackung L
(µH)
IR 1
(mA)
IR 2
(mA)
ISAT
(mA)
RDC
(mΩ)
fres
(MHz)
H
(mm)
IR
(A)
RDC max.
(Ω)
RDC typ.
(Ω)
Muster
614104150121 PDF WR-COM USB 2.0 THT Type A Horizontal Slim Type USB 2.0 Type A Horizontal - Short Type Receptacle 4 THT 1.5 30 Tape and Reel & Mylar
74479775247 PDF WE-PMI Power-Multilayer-Induktivität Low RDC 4.7 600 850 250 250 30 1
7447462470 PDF WE-TI Tonneninduktivität 47 10.6 1.18 0.34 0.221